How To Install A Water Softener ?
Water softening is a technique that serves the removal of the ions that cause the water to be hard, in most cases calcium and magnesium ions. A water softener is a unit that is used to soften water, by removing the minerals that cause the water to be hard. Hard water is not a health risk, but a nuisance because of mineral buildup on fixtures and poor soap and detergent performance. Thus, the water softeners are used for.
You’ve researched and purchased a water softener, the next step is to learn how to install a water softener. Installing the water softener is easy and do- it- yourself project.
First of all, turn off the main water supply by shutting down the main shut off valve. Also turn off the electricity to your hot water heater. Drain your water lines by opening all the plumbing fixtures, even those that are outdoors.
Locate the dry, safe and level place to position the water softener unit. In the case of a two tank softener, position the brine and the resin tanks near one another. Now installing the water softener would require you to insert the distributor tube into the mineral tank. Flush the open end with the tank and rest the screen intake on the bottom’s center point.
Add gravels into the tank, so that they cover up the screen intake. You can make use of a funnel to pour the gravel into the tank. The next step is to add sufficient amount of softener resin into the tank, so that it reaches to about one half of the tank. Take away the tape from the distributor tube.
Affix the top basket to the control valve’s underside and then to the mineral tank. Lubricate the inner o-ring prior to attaching the head to the tank. The hole in the middle of the valve should fit over the distributor tube. Tighten the valve by hand.
Push the bypass valve into the inlet and outlet fittings on the softener head, and secure it with clips. Bypass is then to be connected to the control valve.
Join the softener’s water connections to the bypass. Fill brine tank with about four gallons of water and plug in the control valve. Add 40 pounds of sodium chloride or potassium chloride salt. Set your softener to the backwash stage and the bypass valve into the service position. Open the water supply valve completely once a steady flow of water from the drain appears. Examine your softener for leaks and loose fittings.
Scott Rodgers is a highly skilled author on plumbing works. His stupendous exposure on plumbing works has helped a lot many Lindsay Plumbers and Mc Farland Plumbers . Grab a totally unique version of this article from the Uber Article Directory
Related Articles:
Leave a Comment